Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Other Brand Skidsteer Forums
New Holland Skidsteer Forum
LS-160 starts in service mode - won't crank in run mode
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Dirtballer" data-source="post: 115839" data-attributes="member: 18215"><p>Just put a new head gasket on machine - did not disconnect any wiring (except two sensors on block). At one point, my wrench hit the live-wired solenoid when installing the injector at the front of the engine, but I don't understand how that could cause a problem. Had no problems starting/running prior to taking head off.</p><p>In run mode, solenoid behind seat just clicks. Starts and runs properly in service mode. Had blown 5A EIC fuse - replaced.</p><p>Can anyone provide a quick answer on how to jump/eliminate the seat/seat belt switches if I undo the connector in the engine compartment, as I think this is the problem?</p><p>Thank you for any assistance anyone might offer.</p></blockquote><p></p>
[QUOTE="Dirtballer, post: 115839, member: 18215"] Just put a new head gasket on machine - did not disconnect any wiring (except two sensors on block). At one point, my wrench hit the live-wired solenoid when installing the injector at the front of the engine, but I don't understand how that could cause a problem. Had no problems starting/running prior to taking head off. In run mode, solenoid behind seat just clicks. Starts and runs properly in service mode. Had blown 5A EIC fuse - replaced. Can anyone provide a quick answer on how to jump/eliminate the seat/seat belt switches if I undo the connector in the engine compartment, as I think this is the problem? Thank you for any assistance anyone might offer. [/QUOTE]
Verification
Post reply
Forums
Other Brand Skidsteer Forums
New Holland Skidsteer Forum
LS-160 starts in service mode - won't crank in run mode
Top