Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
lift solenoid and bics system help needed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="sundown57" data-source="post: 98872" data-attributes="member: 13893"><p>I have a older model bobcat 763 it has the bics system with the lights behind your right elbow. Problem is I'm getting 3 flashes from the valve light. some times as soon as I start it some times after using it a few minutes. Checked both green and black wire to the control and don't see any problem so I thought I would check the solenoid. I only get 2.2 OHMs I think it should be more like 10. but not sure. the other problem I have is it is not located in the main valve body. There is another block on the same wall but further back and the solenoid is in the back of that block . there is no nut on the back of it and I can't for life of me figure out how to remove it . there are no screws on the side either. So can any one tell me what the OHMS should be and how to remove it ? Also if any one has any suggestion what else might be causing the light to flash I'm all ears . thanks in advance</p></blockquote><p></p>
[QUOTE="sundown57, post: 98872, member: 13893"] I have a older model bobcat 763 it has the bics system with the lights behind your right elbow. Problem is I'm getting 3 flashes from the valve light. some times as soon as I start it some times after using it a few minutes. Checked both green and black wire to the control and don't see any problem so I thought I would check the solenoid. I only get 2.2 OHMs I think it should be more like 10. but not sure. the other problem I have is it is not located in the main valve body. There is another block on the same wall but further back and the solenoid is in the back of that block . there is no nut on the back of it and I can't for life of me figure out how to remove it . there are no screws on the side either. So can any one tell me what the OHMS should be and how to remove it ? Also if any one has any suggestion what else might be causing the light to flash I'm all ears . thanks in advance [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
lift solenoid and bics system help needed
Top