Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
leaking axle seal on 773
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 1812" data-attributes="member: 82"><p>I didn't realize it was so simple, does it also apply to a 743? I really want to replace my seals just to be sure i don't have any problems later on. As i will be stripping this thing almost rite down i would like to do any repairs that *may* need to be done while it is in bits.</p><p></p><p>It seems that the hubs are welded to the axles, but the manual says something about loosen the bolt in the end on the axle by turning the axle hub. Then it says to re-assemble tighten one bolt to 220-245 ft lbs and another one to 475-525 ft lbs. The only one that i know of is the one that holds the sprocket to the axle *shrugs* unless it is talking about the housing that holds the reduction gearing attached to the hydro motor.</p><p></p><p>ps. sorry for hijacking your post</p></blockquote><p></p>
[QUOTE="Tazza, post: 1812, member: 82"] I didn't realize it was so simple, does it also apply to a 743? I really want to replace my seals just to be sure i don't have any problems later on. As i will be stripping this thing almost rite down i would like to do any repairs that *may* need to be done while it is in bits. It seems that the hubs are welded to the axles, but the manual says something about loosen the bolt in the end on the axle by turning the axle hub. Then it says to re-assemble tighten one bolt to 220-245 ft lbs and another one to 475-525 ft lbs. The only one that i know of is the one that holds the sprocket to the axle *shrugs* unless it is talking about the housing that holds the reduction gearing attached to the hydro motor. ps. sorry for hijacking your post [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
leaking axle seal on 773
Top