Reply to thread

Message: <blockquote data-quote="eboucher.6" data-source="post: 94918" data-attributes="member: 13162"><p>I think you mis understood what I was saying. where the roto swivel attaches to the machine. there are 2 tabs on the machine it bolts to. so you put the outer half of the sheave on, ( drive sheave) followed by the roto swivel cylinder. that whole unit bolts down to the side of the machine. where it bolts to the machine I have two spacers that are roughly 3/4 of an inch. the manual states to make sure to install any spacers that were removed during belt replacement. my question is, can I shorten these spacers with out causing any issues. it would essentially just make the belt ride higher on the drive sheave and force it further into the driven sheave giving me slightly less torque at low range and more speed in high. does anyone have any measurement on the thickness of their spacers? ill will provide picture when I can.</p></blockquote><p></p>