Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
jammed chain 643
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="robmon" data-source="post: 39628" data-attributes="member: 4817"><p>Thanks for that Ken, thankfully I dont need to remove sprocket. Was wondering though is it possible to tighten wheel bearing, i seem to have a little play, about 5mm on each one,in and out ways which means when turning 180 degrees the movement becomes 10mm from side to side if that makes sense?? when doing this under load there was a clunking noise coming from chain area, not sure if it was skipping a tooth on sprocket but sounded like it. also fair amount of play in hydraulic drive motors also about 10mm is this a sign of wear??this means when doing 180dg turn chains may not line up properly between drive sprocket and wheel sprockets</p><p>clunking noise may also have come from a piece of metal floating around in there, tried to upload a pic of it for identification but havent worked that out!! It is a half circle magnetic 8mm thick, 50mm wide no idea what it is from any advise welcomed</p></blockquote><p></p>
[QUOTE="robmon, post: 39628, member: 4817"] Thanks for that Ken, thankfully I dont need to remove sprocket. Was wondering though is it possible to tighten wheel bearing, i seem to have a little play, about 5mm on each one,in and out ways which means when turning 180 degrees the movement becomes 10mm from side to side if that makes sense?? when doing this under load there was a clunking noise coming from chain area, not sure if it was skipping a tooth on sprocket but sounded like it. also fair amount of play in hydraulic drive motors also about 10mm is this a sign of wear??this means when doing 180dg turn chains may not line up properly between drive sprocket and wheel sprockets clunking noise may also have come from a piece of metal floating around in there, tried to upload a pic of it for identification but havent worked that out!! It is a half circle magnetic 8mm thick, 50mm wide no idea what it is from any advise welcomed [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
jammed chain 643
Top