Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Hydraulic Hoses - Check or Replace?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Fishfiles" data-source="post: 62308" data-attributes="member: 782"><p>Yeah Melli , it would work well on the hoses thru the articulating boom knuckle , probally beter , but you would have to take the sock tube off first as I would think it would end up being too thick to put it on top the sock ------------------------ I know I must have over 100 ft of the spiral on my shrimp boat and 40 ft on my fishing boat , used it over fuel lines and wiring harnesses , I even have it wrapping the propane hose between the regulator and burner of the crawfish/ shrimp boiling pot ------------ that web site I linked to is not the place where I buy it from , although it looks to be the exact same I don't know if it is , I was just using that site as a reference , the hydraulic hose machine on my truck is AeroQuip and I buy most all of my hydraulic supplies from the local AeroQuip dealer , AeroQuip and Eaton are now combined and the new fittings say Eaton on them --------- AeroQuip is a little more expensive than say Gates or Parker but I think as far as hose and fitting go it is a better quality , if it is good enough for NASCAR and the Space Shuttle it must be OK</p></blockquote><p></p>
[QUOTE="Fishfiles, post: 62308, member: 782"] Yeah Melli , it would work well on the hoses thru the articulating boom knuckle , probally beter , but you would have to take the sock tube off first as I would think it would end up being too thick to put it on top the sock ------------------------ I know I must have over 100 ft of the spiral on my shrimp boat and 40 ft on my fishing boat , used it over fuel lines and wiring harnesses , I even have it wrapping the propane hose between the regulator and burner of the crawfish/ shrimp boiling pot ------------ that web site I linked to is not the place where I buy it from , although it looks to be the exact same I don't know if it is , I was just using that site as a reference , the hydraulic hose machine on my truck is AeroQuip and I buy most all of my hydraulic supplies from the local AeroQuip dealer , AeroQuip and Eaton are now combined and the new fittings say Eaton on them --------- AeroQuip is a little more expensive than say Gates or Parker but I think as far as hose and fitting go it is a better quality , if it is good enough for NASCAR and the Space Shuttle it must be OK [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Hydraulic Hoses - Check or Replace?
Top