Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hyd valves
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 55997" data-attributes="member: 82"><p>Have you replaced the cylinder seals first? if so, its hopefully your load checks. These will be behind caps on the control block, no need to replace the valve assembly, just the O rings. My 731 did this. I found taht with the engine off, i could move the pedal to lift and it would stop. Replaced the O rings and it was good.</p><p>Get the old ones out, take them to a seal shop and they should be able to match them for a few $, a LOT less than the dealer will want for a seal kit (if still available).</p></blockquote><p></p>
[QUOTE="Tazza, post: 55997, member: 82"] Have you replaced the cylinder seals first? if so, its hopefully your load checks. These will be behind caps on the control block, no need to replace the valve assembly, just the O rings. My 731 did this. I found taht with the engine off, i could move the pedal to lift and it would stop. Replaced the O rings and it was good. Get the old ones out, take them to a seal shop and they should be able to match them for a few $, a LOT less than the dealer will want for a seal kit (if still available). [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
hyd valves
Top