Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
General Skidsteer & Technical Topics
Shop Talk
Electric Power Bob-Tach
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="mtnxtreme " data-source="post: 124406" data-attributes="member: 19337"><p>TriHonu this is probably a stupid question but I looked up these <strong>6731119 - PIVOT, WEDGE, 50 mm (1.95") long pin</strong>. and for the life of me can't figure out where they go and why they need them. Also do you have to set it up so the actuator piston fully closes when in that position or will it just stop when it is in the fully open position ?</p></blockquote><p></p>
[QUOTE="mtnxtreme , post: 124406, member: 19337"] TriHonu this is probably a stupid question but I looked up these [B]6731119 - PIVOT, WEDGE, 50 mm (1.95") long pin[/B]. and for the life of me can't figure out where they go and why they need them. Also do you have to set it up so the actuator piston fully closes when in that position or will it just stop when it is in the fully open position ? [/QUOTE]
Verification
Post reply
Forums
General Skidsteer & Technical Topics
Shop Talk
Electric Power Bob-Tach
Top