Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Disconecting the hydro lines from the drive motor
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Fishfiles" data-source="post: 19349" data-attributes="member: 782"><p>one of the small hoses will continue to leak and needs to be pluged going to the case drain # 6 (3/8 JIC M , the split flange hoses will leak whats in them and stop ( chunk of blue paper towel) , a few pointers , tie the hoses up with some mechanic/tie wire out the way , clean all the dirt from around flanges with air or pressure washing before taking loose and plug up the travel motor inlet ports asap , unless your changing out the unit , use a 1'2 drive deep dish socket on a breaker bar to hold the nut on back of the mounting bolts and an impact on the front side bolt head , if you are removing the sprocket use a pick , air and lubricant to clean the three threaded holes on th sprocket used to push the sprocket off the hub , it's 1/2 nc , a bottoming tap is the way to go to clean the threads before you start , when reinstalling a hub by your self , I put a line up pin (Klien) in a hole on each side and can pick it up and line the holes easily first stab and hold it in with a knee till you get a bolt started , you should clean out the case drain filter while it's down , take care to assembly it back the way it goes as it can be put together a few different ways wrong</p></blockquote><p></p>
[QUOTE="Fishfiles, post: 19349, member: 782"] one of the small hoses will continue to leak and needs to be pluged going to the case drain # 6 (3/8 JIC M , the split flange hoses will leak whats in them and stop ( chunk of blue paper towel) , a few pointers , tie the hoses up with some mechanic/tie wire out the way , clean all the dirt from around flanges with air or pressure washing before taking loose and plug up the travel motor inlet ports asap , unless your changing out the unit , use a 1'2 drive deep dish socket on a breaker bar to hold the nut on back of the mounting bolts and an impact on the front side bolt head , if you are removing the sprocket use a pick , air and lubricant to clean the three threaded holes on th sprocket used to push the sprocket off the hub , it's 1/2 nc , a bottoming tap is the way to go to clean the threads before you start , when reinstalling a hub by your self , I put a line up pin (Klien) in a hole on each side and can pick it up and line the holes easily first stab and hold it in with a knee till you get a bolt started , you should clean out the case drain filter while it's down , take care to assembly it back the way it goes as it can be put together a few different ways wrong [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Disconecting the hydro lines from the drive motor
Top