Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Damaged lift cylinder head - repair or replace?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="laurencen" data-source="post: 127952" data-attributes="member: 14082"><p>its for a wiper seal, myself I would try to push the area deformed back in place, clean it up and use it as is, there is no pressure on it so should be good to use, if you are concerned clean well, rough the surfaces and build up with epoxy, then use a lathe to recut the groove</p></blockquote><p></p>
[QUOTE="laurencen, post: 127952, member: 14082"] its for a wiper seal, myself I would try to push the area deformed back in place, clean it up and use it as is, there is no pressure on it so should be good to use, if you are concerned clean well, rough the surfaces and build up with epoxy, then use a lathe to recut the groove [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Damaged lift cylinder head - repair or replace?
Top