Reply to thread

Message: <blockquote data-quote="Rambler" data-source="post: 133145" data-attributes="member: 19227"><p>Thank you for the reply.  The one link was off since I had been testing it with and without the two links connected to the spool.  The spool makes the pop with one or both links attached.  Also it only pops when the linkage is attached and the spool is push in.  If I disconnect the linkage and push the spool in with a screw driver it does not pop. I have disconnected the cross lever from the spool and there is no jerking motion when using the pedals,  I did use the correct seal per the Bobcat Bulletin..  Regarding purging air,  I refilled the Hydraulic tank, let it sit overnight, then started it and let it run for 15 minutes.  At start some grinding, but it disappeared.  This is stumping me.</p></blockquote><p></p>