Reply to thread

Message: <blockquote data-quote="devo" data-source="post: 133741" data-attributes="member: 24563"><p>Yes, I fixed it. I did the same things at first too including changing pins and linkages and welding worn out spots on the plate. None of that worked. I ended up just putting in half inch shims under both springs. I clamped and wired the springs closed to fit the steel shims, re-installed the springs and cut the wires. For shims I just used some old nuts and honed them out a bit, the nuts are about 3/8" thick. I Installed the shims at the bottom on top of the washer and under the spring (closest to the pin). Hope this helps. I have attached a picture looking down from the bucket at the springs. [ATTACH=full]5971[/ATTACH]</p></blockquote><p></p>