Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bucket does not TILT UP on a 853
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="toolnut" data-source="post: 5952" data-attributes="member: 809"><p>Hello everyone, I am new to the forum and bobcat ownship. I am very glad to find this wonderful site. I just bought a 89 853 loader. It has problem with the tilt control. The engine runs fine and the loader drives well. The lift controls are a little touchy/jerky but they work. However, the tilt cylinder only goes one way: down/forward. When I press the heel down, I can hear some hydraulic noise from below the seat, but the bucket does not move at all. I did some trouble shooting by disconnecting the hydraulic lines at each end of the tilt cylinder. The bucket moves back up if i disconnect the hydraulic line at the base of the tilt cyclinder. This suggests that there is some kind of blockage that prevent the hydraulic fluid from returning. I am not familiar with Bobcat hydraulics at all. I am curious if there are some kind of check valve(s) that may be stuck shut some where? thanks in advance for any help. toolnut</p></blockquote><p></p>
[QUOTE="toolnut, post: 5952, member: 809"] Hello everyone, I am new to the forum and bobcat ownship. I am very glad to find this wonderful site. I just bought a 89 853 loader. It has problem with the tilt control. The engine runs fine and the loader drives well. The lift controls are a little touchy/jerky but they work. However, the tilt cylinder only goes one way: down/forward. When I press the heel down, I can hear some hydraulic noise from below the seat, but the bucket does not move at all. I did some trouble shooting by disconnecting the hydraulic lines at each end of the tilt cylinder. The bucket moves back up if i disconnect the hydraulic line at the base of the tilt cyclinder. This suggests that there is some kind of blockage that prevent the hydraulic fluid from returning. I am not familiar with Bobcat hydraulics at all. I am curious if there are some kind of check valve(s) that may be stuck shut some where? thanks in advance for any help. toolnut [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bucket does not TILT UP on a 853
Top