Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
General Discussion Forums
General Chit Chat
Brain fried
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Whatthef" data-source="post: 132523" data-attributes="member: 24443"><p>Try this, froze my mustang2040, started her up and tried to move,blew out filter gasket all my H oil on the ground, with brakes locked pulled into heated shop, did I mention it was near 40 below Celsius, Damm it was cold, so thawed out ,reset oil filter gasket, refilled H oil but no hydraulic response,brakes do not unlock at any rpm,no arm or bucket movement, tiny bit of reverse on right side but can't move because brakes won't unlock.All fuses ok, control module lites are on other than a few non important ones, All switches function.Wonder if that solenoid under operators seat left side attached to some kind of block hydraulic lines attached or did I do something to my pump.Appreciate any help,thanks for listening,Mark.</p></blockquote><p></p>
[QUOTE="Whatthef, post: 132523, member: 24443"] Try this, froze my mustang2040, started her up and tried to move,blew out filter gasket all my H oil on the ground, with brakes locked pulled into heated shop, did I mention it was near 40 below Celsius, Damm it was cold, so thawed out ,reset oil filter gasket, refilled H oil but no hydraulic response,brakes do not unlock at any rpm,no arm or bucket movement, tiny bit of reverse on right side but can't move because brakes won't unlock.All fuses ok, control module lites are on other than a few non important ones, All switches function.Wonder if that solenoid under operators seat left side attached to some kind of block hydraulic lines attached or did I do something to my pump.Appreciate any help,thanks for listening,Mark. [/QUOTE]
Verification
Post reply
Forums
General Discussion Forums
General Chit Chat
Brain fried
Top
