Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat m444 not moving left or right, shaft spinning freely?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Jesset1234" data-source="post: 117990" data-attributes="member: 21340"><p>Hey all, 1963 m444, not moving anywhere, engine starts and revs fine. The front pulley/sheave just spinning freely on the shaft. I removed the belt and slid the sheave/pulley to the side and revealed the shaft, there is no rectangle key on the shaft, and its a little rounded off. Any issues of replacing the key, tightening the set screws and then welding the pulley onto the shaft? Just looking for ideas here[ATTACH=full]1613[/ATTACH]</p></blockquote><p></p>
[QUOTE="Jesset1234, post: 117990, member: 21340"] Hey all, 1963 m444, not moving anywhere, engine starts and revs fine. The front pulley/sheave just spinning freely on the shaft. I removed the belt and slid the sheave/pulley to the side and revealed the shaft, there is no rectangle key on the shaft, and its a little rounded off. Any issues of replacing the key, tightening the set screws and then welding the pulley onto the shaft? Just looking for ideas here[ATTACH type="full"]1613[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat m444 not moving left or right, shaft spinning freely?
Top