Visit our tractor and agricultural equipment communities:

Ingersoll Forum Case IH Forum Combine Forum Hay Forum

JCB Forum John Deere Forum Kubota Forum Mahindra Forum

Massey Ferguson Talk New Holland Forum Valtra Forum Yanmar Forum

Zetor Forum Farming Forum

Reply to thread

Help Support SkidSteer Forum:

Message: <blockquote data-quote="Timjame" data-source="post: 103444" data-attributes="member: 16402"><p>Hello all. New to this forum. I've been searching through this and other places for an answer or direction for a few weeks but can't seem to pinpoint my issue. Hopefully I can put this problem to rest! It's driving me nuts. I have a 99 bobcat 863F (non AHC). I bought this machine a month ago needing a new turbo. When I bought it I watched with my own eyes the bucket curl and arms lift. I put it on my trailer and drove it home. As soon as I get it home I noticed that the arms wouldn't lift. The pedal was locked-solid. I made sure the safety bar was down and the bar pressed the manual lock then I pressed the operate button. Nothing. The bucket curled but no arm movement because the pedal was locked. I just figured I was doing something wrong. All lights (on panel below my right arm) are lit when I try to move the lift pedal. After I finished the turbo replacement I changed all filters and hydraulic fluid. Noticed the same problem existed. Left (lift pedal) locked but tilt is fine. I'm not familiar enoug with this machine to figure it out just yet. I swapped coils on the top of the valve control block. No change. Does this machine have a solenoid lock? Could the pedal lock if it has no pressure? Feels like some actual pin internally is holding it in place. I can disconnect the linkage from the pedal to the spool and it's not in the linkage. It won't budge from the block. Any help is greatly appreciated!!</p></blockquote><p></p>

Verification