Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 863 boom arms won't raise unless bucket is tilted back at same time
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="clewis" data-source="post: 129800" data-attributes="member: 23890"><p>I went ahead and swapped the lock valves for tilt and lift on the BICS to see if the problem would swap pedals but no luck. No visible leaks at either end of the spools so I doubt that's the problem but who knows. I worked with the machine on the farm all day today. Noticed by accident that the lift and tilt would still work, but barely, if I attempted to use the controls while in lockout. I figure the most cost effective route would be to order the full reseal kit for the control valve rather than order the separate kits one by one until I found the problem. The load checks were cheap enough so I ordered them too. Should all be here thursday from bobcat. Will give me a good chance to check everything out as I replace the seals. I'll report back with my findings. Thanks.</p></blockquote><p></p>
[QUOTE="clewis, post: 129800, member: 23890"] I went ahead and swapped the lock valves for tilt and lift on the BICS to see if the problem would swap pedals but no luck. No visible leaks at either end of the spools so I doubt that's the problem but who knows. I worked with the machine on the farm all day today. Noticed by accident that the lift and tilt would still work, but barely, if I attempted to use the controls while in lockout. I figure the most cost effective route would be to order the full reseal kit for the control valve rather than order the separate kits one by one until I found the problem. The load checks were cheap enough so I ordered them too. Should all be here thursday from bobcat. Will give me a good chance to check everything out as I replace the seals. I'll report back with my findings. Thanks. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 863 boom arms won't raise unless bucket is tilted back at same time
Top