Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 743 - Starts then dies
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Cary E Sip Sr" data-source="post: 126406" data-attributes="member: 22663"><p>I just had similar problem last winter after boys ran it out of fuel . Primer bulbs suck in cold weather , especially when they are mounted where you can't reach them. I believe book said open bleeder on filter first and prime. I gave up on bulb and used air hose in tank to get good fuel volume at filter . Close filter bleeder , open bleeder on injector pump., prime again and start. After running good , then close injector bleeder. At that point mine ran fine , if not , I may have proceeded to crack injector lines but didn't have too. If fuel is flowing to both bleeders , but not injectors , I would suspect injector pump trouble . Eliminate the simple things first ,( like screens on suction tubes , my pet peeve ) , by the time you get to injector pump problems you're talking $ .</p></blockquote><p></p>
[QUOTE="Cary E Sip Sr, post: 126406, member: 22663"] I just had similar problem last winter after boys ran it out of fuel . Primer bulbs suck in cold weather , especially when they are mounted where you can't reach them. I believe book said open bleeder on filter first and prime. I gave up on bulb and used air hose in tank to get good fuel volume at filter . Close filter bleeder , open bleeder on injector pump., prime again and start. After running good , then close injector bleeder. At that point mine ran fine , if not , I may have proceeded to crack injector lines but didn't have too. If fuel is flowing to both bleeders , but not injectors , I would suspect injector pump trouble . Eliminate the simple things first ,( like screens on suction tubes , my pet peeve ) , by the time you get to injector pump problems you're talking $ . [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 743 - Starts then dies
Top