Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 743 drives opposite of controls
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Ctjr88" data-source="post: 119575" data-attributes="member: 21761"><p>Hi, I have a 743 that I just replaced the whole drive pump assembly, that I got from LPS. Also had got the rebuild kits for the drive motors. Got the new pump installed and the motors rebuilt and back in. Started it up and it didn't want to move really and what little it did was opposite of the direction of the controls. Went through some threads on here and found to check my port block. Pulled it out went through it with not finding much. But I did tighten the fitting with spring and poppet for the charge pressure tighter then it was. Now the machine moves but still opposite. I did hook a pressure gauge to the charge line but doesn't look like there is much pressure there, since my gauge is marked at 100psi increments. My serial is 22588 so I have the port block on the side not the one on top of the pump with the brass filter.</p></blockquote><p></p>
[QUOTE="Ctjr88, post: 119575, member: 21761"] Hi, I have a 743 that I just replaced the whole drive pump assembly, that I got from LPS. Also had got the rebuild kits for the drive motors. Got the new pump installed and the motors rebuilt and back in. Started it up and it didn't want to move really and what little it did was opposite of the direction of the controls. Went through some threads on here and found to check my port block. Pulled it out went through it with not finding much. But I did tighten the fitting with spring and poppet for the charge pressure tighter then it was. Now the machine moves but still opposite. I did hook a pressure gauge to the charge line but doesn't look like there is much pressure there, since my gauge is marked at 100psi increments. My serial is 22588 so I have the port block on the side not the one on top of the pump with the brass filter. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 743 drives opposite of controls
Top