Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 742 Hydrostatic Pump
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Dmc10140" data-source="post: 98263" data-attributes="member: 14225"><p>Hey guys, I am new to the group and bobcat ownership. I just picked up a basket case 742. It was retired from a paper-mill, where the previous owner purchased it. It had several hydraulic leaks (lines) and the hydrostatic pump was leaking at the end. He decided to pull the hydrostatic pump, and dismantle it (he worked for Bobcat) at the time. So i have a machine sitting at my house that has not run in several years with a dismantled pump. He included a seal kit with it, but i wanted to go over everything before i put it back together. Below are a few questions I have: 1. The Wafer plates look good, there is slight wear on both. I believe after reading some posts that these can be sanded smooth again. The one got a little ding in it during transport, I am not sure if this is repairable. Would a picture help? 2. The yoke in the input side appears to have some slight scratches/grooving on the face of it. Is this normal? The rotating assembly seems slightly worn on the piston side as well vs the back side. 3.How do I tell which wafer plate goes to which side? 4.Does anyone have a electronic copy of the rebuild manual for the ta1919 pump? I have not been able to find anything. Thanks for the help.</p></blockquote><p></p>
[QUOTE="Dmc10140, post: 98263, member: 14225"] Hey guys, I am new to the group and bobcat ownership. I just picked up a basket case 742. It was retired from a paper-mill, where the previous owner purchased it. It had several hydraulic leaks (lines) and the hydrostatic pump was leaking at the end. He decided to pull the hydrostatic pump, and dismantle it (he worked for Bobcat) at the time. So i have a machine sitting at my house that has not run in several years with a dismantled pump. He included a seal kit with it, but i wanted to go over everything before i put it back together. Below are a few questions I have: 1. The Wafer plates look good, there is slight wear on both. I believe after reading some posts that these can be sanded smooth again. The one got a little ding in it during transport, I am not sure if this is repairable. Would a picture help? 2. The yoke in the input side appears to have some slight scratches/grooving on the face of it. Is this normal? The rotating assembly seems slightly worn on the piston side as well vs the back side. 3.How do I tell which wafer plate goes to which side? 4.Does anyone have a electronic copy of the rebuild manual for the ta1919 pump? I have not been able to find anything. Thanks for the help. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 742 Hydrostatic Pump
Top