Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 732 Engine won't pull out
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="JeffZ" data-source="post: 137883" data-attributes="member: 23561"><p>I have an old (age undetermined since the model/serial number plate is missing) 732 that has a large hydraulic leak. Need to pull the engine to clean up the huge mess so I can track down the problem. Have everything disconnected that's necessary and removed the 4 bolts holding the mounting plate to the frame. Hooked up an engine hoist to lift the rear of the engine an inch to clear the frame but the engine won't release from the hydro static pump. I assume the splines are rusted to the u-joint/hub. I can swing the rear of the engine back and forth a good 4- 6 inches, but it won't release. Don't know how hard I can pull without damaging the hydraulic seal?</p><p></p><p>Any thoughts?</p><p></p><p>Thanks!</p></blockquote><p></p>
[QUOTE="JeffZ, post: 137883, member: 23561"] I have an old (age undetermined since the model/serial number plate is missing) 732 that has a large hydraulic leak. Need to pull the engine to clean up the huge mess so I can track down the problem. Have everything disconnected that's necessary and removed the 4 bolts holding the mounting plate to the frame. Hooked up an engine hoist to lift the rear of the engine an inch to clear the frame but the engine won't release from the hydro static pump. I assume the splines are rusted to the u-joint/hub. I can swing the rear of the engine back and forth a good 4- 6 inches, but it won't release. Don't know how hard I can pull without damaging the hydraulic seal? Any thoughts? Thanks! [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 732 Engine won't pull out
Top
