Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 642B rough running question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="jerry" data-source="post: 55181" data-attributes="member: 931"><p>Check to make sure you have the plug wire routed right, the firing order should be cast into the manifold. Make sure the point gap is right , don't guess at it or if you have to put the points on top of a lobe and set to .015 or .020 that should get you going. Make sure you did not disconnect the vacuum advance hose on the distributer The gap depends on which engine you have in the machine.</p></blockquote><p></p>
[QUOTE="jerry, post: 55181, member: 931"] Check to make sure you have the plug wire routed right, the firing order should be cast into the manifold. Make sure the point gap is right , don't guess at it or if you have to put the points on top of a lobe and set to .015 or .020 that should get you going. Make sure you did not disconnect the vacuum advance hose on the distributer The gap depends on which engine you have in the machine. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 642B rough running question
Top