Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 630 Reclamation
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="peebeeaitch" data-source="post: 61999" data-attributes="member: 8318"><p>I cannot seem to find the specs for the Torx socket for loosening the drive motor bolts. I have up to an E16 socket. It seems close. Is it an E20 (the circumscribed circle diameter is 18.5mm)?</p><p>The nut for removing "The Block" from the pump stack seems to be 54mm AF. This is roughly a 2 1/8" wrench. Is this correct? Or should I just turn the thing over, clamp the nut in a vice and use the stack as a wrench?</p><p>The feed line from the reservoir to "The Block" is roughly 35mm AF. This is 1 3/8". Is this correct?</p><p>The motor to brake disk washer locking bolts are roughly 45mm AF. This is, again roughly, 1 3/4". Is this correct?</p><p>The Torx bit for separating the hydrostatic pumps from the manifold block is Torx E10, so there is some useful information for someone out there.</p><p>I want to burn the "wrenches" on the laser in this week so hopefully I will be able to complete the teardown this weekend.</p><p>Thanks in advance.</p><p>PBH</p></blockquote><p></p>
[QUOTE="peebeeaitch, post: 61999, member: 8318"] I cannot seem to find the specs for the Torx socket for loosening the drive motor bolts. I have up to an E16 socket. It seems close. Is it an E20 (the circumscribed circle diameter is 18.5mm)? The nut for removing “The Block” from the pump stack seems to be 54mm AF. This is roughly a 2 1/8” wrench. Is this correct? Or should I just turn the thing over, clamp the nut in a vice and use the stack as a wrench? The feed line from the reservoir to “The Block” is roughly 35mm AF. This is 1 3/8”. Is this correct? The motor to brake disk washer locking bolts are roughly 45mm AF. This is, again roughly, 1 3/4”. Is this correct? The Torx bit for separating the hydrostatic pumps from the manifold block is Torx E10, so there is some useful information for someone out there. I want to burn the “wrenches” on the laser in this week so hopefully I will be able to complete the teardown this weekend. Thanks in advance. PBH [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 630 Reclamation
Top