Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bobcat 610 removal of varable speed pulley
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="walio123" data-source="post: 105993" data-attributes="member: 9827"><p>.I will describe what should be done if you have already taken half of the pulley.There are 2-or 3 modelsVariable drive sheave with roto swivel inside or wtih roto swivel outside. For roto swive linside - remove the large snap ring and pull the piston with swivel out of the stationary half sheave.Use 2 pry bars to do it. Remove bolt and holding washer from hte end of variable speed ,remove washer from bolt, an tighten bolt back. Install 1/4 bolts in to holes in fixed sheave hub. Install puller behid bolts and remove sheave. For roto swivel outside- Remove holding bolt and washer from end on ctankshaft.Use puller to remove other half.</p></blockquote><p></p>
[QUOTE="walio123, post: 105993, member: 9827"] .I will describe what should be done if you have already taken half of the pulley.There are 2-or 3 modelsVariable drive sheave with roto swivel inside or wtih roto swivel outside. For roto swive linside - remove the large snap ring and pull the piston with swivel out of the stationary half sheave.Use 2 pry bars to do it. Remove bolt and holding washer from hte end of variable speed ,remove washer from bolt, an tighten bolt back. Install 1/4 bolts in to holes in fixed sheave hub. Install puller behid bolts and remove sheave. For roto swivel outside- Remove holding bolt and washer from end on ctankshaft.Use puller to remove other half. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bobcat 610 removal of varable speed pulley
Top
