Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
Bobcat Excavators
Bobcat 331 diagnostic couplers
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Fishfiles" data-source="post: 43176" data-attributes="member: 782"><p>if you swopped the hoses and the problem changed position then a section of the pump is bad , the reliefs are on each bank of valves that is supplied by a stage of the pump -------- with you machine in this condition you can see how the power beyond works by slightly cocking open a function that is not effected while operating a function that is affected , you should find a sweet spot where the unused flow will transfer to the weak curcuit and make it work better -----------if the section is available seperately for your pump ( depending on serial number ) then it is not hard to change but pricey , sometimes the sections are available and sometimes not , what you should do is disassemble the pump and see how the other sections look as you might change one and the other go out a few months down the line and I'd bet buying one sections is going to cost you more than half of all three as an assembly ---diver down</p></blockquote><p></p>
[QUOTE="Fishfiles, post: 43176, member: 782"] if you swopped the hoses and the problem changed position then a section of the pump is bad , the reliefs are on each bank of valves that is supplied by a stage of the pump -------- with you machine in this condition you can see how the power beyond works by slightly cocking open a function that is not effected while operating a function that is affected , you should find a sweet spot where the unused flow will transfer to the weak curcuit and make it work better -----------if the section is available seperately for your pump ( depending on serial number ) then it is not hard to change but pricey , sometimes the sections are available and sometimes not , what you should do is disassemble the pump and see how the other sections look as you might change one and the other go out a few months down the line and I'd bet buying one sections is going to cost you more than half of all three as an assembly ---diver down [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
Bobcat Excavators
Bobcat 331 diagnostic couplers
Top