Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 310 clutch adjustment and other info
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="speedbuff" data-source="post: 50489" data-attributes="member: 6781"><p>Itoo have heard horror stories of bobcats mixing oils and subsiquent failures however on these units you can use 10w30 or 10w40 engine oil instead of clark part#6563328 this is right out of the bobcat manual .I suspect that this is due to the fact that there is no hydrostatic drive used on this unit only belts there is just a very small hydraulic pump to run the loader .The drive system is belt drive to the clutches and I am struggeling with it right now .On my unit someone has removed the factory clutches and replaced them with a direct drive pulley .I would really like to get the 2 speed option back but it is sort of cost prohibitive through bobcat as I need both clutches .I am sure someone else besides bobcat has used these somewhere along the line but I have not even ever seen what they should look like .Could someone post a picture or even a parts breakdown of the belt clutch for a 310 or 313 ??</p></blockquote><p></p>
[QUOTE="speedbuff, post: 50489, member: 6781"] Itoo have heard horror stories of bobcats mixing oils and subsiquent failures however on these units you can use 10w30 or 10w40 engine oil instead of clark part#6563328 this is right out of the bobcat manual .I suspect that this is due to the fact that there is no hydrostatic drive used on this unit only belts there is just a very small hydraulic pump to run the loader .The drive system is belt drive to the clutches and I am struggeling with it right now .On my unit someone has removed the factory clutches and replaced them with a direct drive pulley .I would really like to get the 2 speed option back but it is sort of cost prohibitive through bobcat as I need both clutches .I am sure someone else besides bobcat has used these somewhere along the line but I have not even ever seen what they should look like .Could someone post a picture or even a parts breakdown of the belt clutch for a 310 or 313 ?? [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 310 clutch adjustment and other info
Top