Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bob cat 632 overheating hydrolics
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 97322" data-attributes="member: 82"><p>The only way to check the drive pump pressur is to remove the lines to the motors and install a gauge. Slowly push the stucks forward to build up pressure, it should get to about 5,000 PSI.</p><p>You may still be getting to this figure, but if it's cavetating, it will heat up.</p></blockquote><p></p>
[QUOTE="Tazza, post: 97322, member: 82"] The only way to check the drive pump pressur is to remove the lines to the motors and install a gauge. Slowly push the stucks forward to build up pressure, it should get to about 5,000 PSI. You may still be getting to this figure, but if it's cavetating, it will heat up. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bob cat 632 overheating hydrolics
Top