Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bob cat 632 overheating hydrolics
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Vern 632" data-source="post: 97300" data-attributes="member: 13930"><p>In checking pressures the repair manuel is not clear on where and how to check the pressure going to the drive motors, it shows how to check the charge pressure and the hydrolic pump pressure at the aux. port. it shows that the pressure switch on the port block is rated at 23-27 psi. and that the pressure at the aux port should be 1700-1800 psi but no place do I find the pressure for the lines going to the drive motors. Any ideas??</p></blockquote><p></p>
[QUOTE="Vern 632, post: 97300, member: 13930"] In checking pressures the repair manuel is not clear on where and how to check the pressure going to the drive motors, it shows how to check the charge pressure and the hydrolic pump pressure at the aux. port. it shows that the pressure switch on the port block is rated at 23-27 psi. and that the pressure at the aux port should be 1700-1800 psi but no place do I find the pressure for the lines going to the drive motors. Any ideas?? [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bob cat 632 overheating hydrolics
Top