Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
BICS Solenoid - Lift and Tilt issue
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="george.schneider@otgbrew." data-source="post: 128140" data-attributes="member: 23135"><p>763 Bobcat</p><p></p><p>Hello,</p><p>I'm trying to trace down an issue with my tilt and lift not relieving pressure on the cylinders.</p><p></p><p>I was wondering does anyone know a good resistance to the solenoid coil on the BICS directional control valve? I'm getting 10 ohms which seems low to my knowledge?</p><p></p><p>I bench tested the BICS directional control valve and it moves a little.</p><p>I also pulled both of the pilot activated directional control valves on the BICS, the orings and backingrings look good, and the valves both move and spring back.</p><p></p><p>If I pull the manual lift release it is the only way I can get the tilt and lift to move back down.</p><p></p><p>All the BICS safety lights are on. (seat, bar,...etc.)</p><p></p><p>George</p></blockquote><p></p>
[QUOTE="george.schneider@otgbrew., post: 128140, member: 23135"] 763 Bobcat Hello, I'm trying to trace down an issue with my tilt and lift not relieving pressure on the cylinders. I was wondering does anyone know a good resistance to the solenoid coil on the BICS directional control valve? I'm getting 10 ohms which seems low to my knowledge? I bench tested the BICS directional control valve and it moves a little. I also pulled both of the pilot activated directional control valves on the BICS, the orings and backingrings look good, and the valves both move and spring back. If I pull the manual lift release it is the only way I can get the tilt and lift to move back down. All the BICS safety lights are on. (seat, bar,...etc.) George [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
BICS Solenoid - Lift and Tilt issue
Top