Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
axle bearings on 642B
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 50441" data-attributes="member: 82"><p>I assume these are two piece axles, are there bolts on the hubs? If so, un-do them a few turns, they will be really tight. Use two hydraulic bottle jacks, one on each side of the axle hub, pump them up and strick the bolt head with a hammer till it cracks free.</p><p>You open the chain case, remove the bolts on the end of the sprockets. With them removed, keep pumping one of the jacks on the hub to pull the axle out. With them out, i use a long metal bar to slide inside the axle tube and knock the cups out of the axle tubes. You will need to pull them off the axles too, i have installed them with a pin punch before, but a piece of water pipe large enough to go over the axle will work to knock them back on.</p></blockquote><p></p>
[QUOTE="Tazza, post: 50441, member: 82"] I assume these are two piece axles, are there bolts on the hubs? If so, un-do them a few turns, they will be really tight. Use two hydraulic bottle jacks, one on each side of the axle hub, pump them up and strick the bolt head with a hammer till it cracks free. You open the chain case, remove the bolts on the end of the sprockets. With them removed, keep pumping one of the jacks on the hub to pull the axle out. With them out, i use a long metal bar to slide inside the axle tube and knock the cups out of the axle tubes. You will need to pull them off the axles too, i have installed them with a pin punch before, but a piece of water pipe large enough to go over the axle will work to knock them back on. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
axle bearings on 642B
Top