Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Anyone tried to straighten a cylinder rod?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Bobpuddy" data-source="post: 21116" data-attributes="member: 1762"><p>Yes that is what I am doing now because I called a couple hydraulic shops and they said because the rod is hardened it would most likely snap or be phone to being weak. The bobcat dealer siad that was their experence as well and they would not attemp straightening because of libility issues. I also asked the repair shop and a machine shop the cost of making a replacement rod and all were around $300. New from bobcat is $400. I'm searching for a used cylinder now</p></blockquote><p></p>
[QUOTE="Bobpuddy, post: 21116, member: 1762"] Yes that is what I am doing now because I called a couple hydraulic shops and they said because the rod is hardened it would most likely snap or be phone to being weak. The bobcat dealer siad that was their experence as well and they would not attemp straightening because of libility issues. I also asked the repair shop and a machine shop the cost of making a replacement rod and all were around $300. New from bobcat is $400. I'm searching for a used cylinder now [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Anyone tried to straighten a cylinder rod?
Top