Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
General Skidsteer & Technical Topics
Shop Talk
anyone built a snow pusher?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="bludorbronc" data-source="post: 27333" data-attributes="member: 2047"><p>i have a 65 inch bucket and a 7 foot power angle snow blade off my 4 wheel drive. it mounted to my truck with two pins into the bottom frame mount and a chain to the hydro cyl. for lift. i made a mount into the bucket that takes the same two pins for mounting and angling the bucket up picks the blade up and the auxilary hydrulics on the bobcat operate the angling cyl. i worked out so when the blade was fully angled it overlapped the outside edge of the bucket by about 2 inches.</p></blockquote><p></p>
[QUOTE="bludorbronc, post: 27333, member: 2047"] i have a 65 inch bucket and a 7 foot power angle snow blade off my 4 wheel drive. it mounted to my truck with two pins into the bottom frame mount and a chain to the hydro cyl. for lift. i made a mount into the bucket that takes the same two pins for mounting and angling the bucket up picks the blade up and the auxilary hydrulics on the bobcat operate the angling cyl. i worked out so when the blade was fully angled it overlapped the outside edge of the bucket by about 2 inches. [/QUOTE]
Verification
Post reply
Forums
General Skidsteer & Technical Topics
Shop Talk
anyone built a snow pusher?
Top