Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
909 backhoe attachment
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Pbotter" data-source="post: 20453" data-attributes="member: 2207"><p>Hi Guys, Got a problem I need a little help with. Bought a 1997 773 Bobcat. When I got it the guy told me he unhooked the aux. because they ran all the time. (he unhooked it up in the switch panel were someone had straight wired it.) Wasn't a problem until I bought my 709 attachment and I found out what was going on. Apparently the aux. switch or the module has went bad and someone straight wired the aux. so when you turn the switch on the aux. automaticly kicks in. I have a manual and ohm the switch on the right steering along with the solenoids on the actuator valve and they seem to be good. Is there any way to check the aux. switch or module. I have no lights on at all when I hit the aux. switch. I know I can put me a toggle switch on the way it's wired now and get by, but I'd rather have it fixed right if it doesn't cost a fortune. Please help!!!!!! Thanks, Jimmy</p></blockquote><p></p>
[QUOTE="Pbotter, post: 20453, member: 2207"] Hi Guys, Got a problem I need a little help with. Bought a 1997 773 Bobcat. When I got it the guy told me he unhooked the aux. because they ran all the time. (he unhooked it up in the switch panel were someone had straight wired it.) Wasn't a problem until I bought my 709 attachment and I found out what was going on. Apparently the aux. switch or the module has went bad and someone straight wired the aux. so when you turn the switch on the aux. automaticly kicks in. I have a manual and ohm the switch on the right steering along with the solenoids on the actuator valve and they seem to be good. Is there any way to check the aux. switch or module. I have no lights on at all when I hit the aux. switch. I know I can put me a toggle switch on the way it's wired now and get by, but I'd rather have it fixed right if it doesn't cost a fortune. Please help!!!!!! Thanks, Jimmy [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
909 backhoe attachment
Top