Reply to thread

Message: <blockquote data-quote="BC873G" data-source="post: 103926" data-attributes="member: 14887">The Bobcat Controller is under the cab. It will be on the left side behind a panel. I think the panel has 4 bolts to remove to expose the controller.Here are a few things to try. Also, if you update your email address on your profile there might be some info from the service manual that may help that I can scan and send. The manual lists all checks by error code. Can you check for error codes again and see if anything comes up? Make sure that you do not shutdown the power before checking for the code.1. Have you checked the fuel pull fuse (F6) for voltage? Should be 12v. It should also be wire 1310 coming from battery.2. When you pull the panel for the controller you will want to remove connector J3. The wires involved are numbered 8150, and 8110. 8100 goes back to the fuel shutoff solenoid from the relay. 8100 should be in connector 403 pin E. If you pull the un-switched power fuse (F4) you can should check continuity between J3, pin C2, wire 8110 with all other J3 pins. If you find continuity then you have a harness problem.It's going to be tough if you don't have any codes.</blockquote>