Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
863 wont start says "input" "reply"
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Fishfiles" data-source="post: 34133" data-attributes="member: 782"><p>Old Machinist gave you good info , it's either a wiring problem , a bad left or right panel , or a controller , one thing I seen a lot was the 2 bolts that hold the middle dash section in rubs a hole in the harness , the bolt on the left side mostly , also seen water/moisture cause that problem , has it been raining alot , hair dryer works for that , I'd check the wiring all the way from the right side to the controller and all plugs in between , it would be great if you had another machine that you could swop panels one at a time , I have seen a controller do that , and would lean more to that as being the problem</p></blockquote><p></p>
[QUOTE="Fishfiles, post: 34133, member: 782"] Old Machinist gave you good info , it's either a wiring problem , a bad left or right panel , or a controller , one thing I seen a lot was the 2 bolts that hold the middle dash section in rubs a hole in the harness , the bolt on the left side mostly , also seen water/moisture cause that problem , has it been raining alot , hair dryer works for that , I'd check the wiring all the way from the right side to the controller and all plugs in between , it would be great if you had another machine that you could swop panels one at a time , I have seen a controller do that , and would lean more to that as being the problem [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
863 wont start says "input" "reply"
Top