Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
863 bobtach bent bad by loader arms
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 133929" data-attributes="member: 82"><p>You did a good job....</p><p></p><p>I have never damaged one here, i have repaired ones that tore where the ram joins to the bobtach, the material on the outside looks thinner than the other side, no idea why they'd do it that way.</p><p></p><p>Your biggest issue will be getting things straight, you need it so the pivot points are in perfect alignment, or you twist the bobtach and it will bind, i have done it before in the arms where the taper is, i line bored them so they were straight and welded home made bosses in place with a pin that went from side to side so it was dead straight for welding. You may need to think of a way to make sure things are held straight when welding</p></blockquote><p></p>
[QUOTE="Tazza, post: 133929, member: 82"] You did a good job.... I have never damaged one here, i have repaired ones that tore where the ram joins to the bobtach, the material on the outside looks thinner than the other side, no idea why they'd do it that way. Your biggest issue will be getting things straight, you need it so the pivot points are in perfect alignment, or you twist the bobtach and it will bind, i have done it before in the arms where the taper is, i line bored them so they were straight and welded home made bosses in place with a pin that went from side to side so it was dead straight for welding. You may need to think of a way to make sure things are held straight when welding [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
863 bobtach bent bad by loader arms
Top