Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
853 control valve questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 16070" data-attributes="member: 82"><p>Thats a good question.... Mine didn't have them, i actually set mine up 90 degrees to the wear marks inside the housing. I know it will rotate on its own a little but but i still tried. I don't know if the travel will be long enough for the balls to escape through the cut outs. I can't see them being for installation as there are pliers that are used for this. If it was me, I'd line it up so that its running in fresh metal inside the cup but not so that if the balls slid all the way forward they would pop out the cut outs, if that makes sense. I'd like for it to run on a nice un-worn section. Also i added a bit of grease to the inside of mine, figured it can't hurt.</p></blockquote><p></p>
[QUOTE="Tazza, post: 16070, member: 82"] Thats a good question.... Mine didn't have them, i actually set mine up 90 degrees to the wear marks inside the housing. I know it will rotate on its own a little but but i still tried. I don't know if the travel will be long enough for the balls to escape through the cut outs. I can't see them being for installation as there are pliers that are used for this. If it was me, I'd line it up so that its running in fresh metal inside the cup but not so that if the balls slid all the way forward they would pop out the cut outs, if that makes sense. I'd like for it to run on a nice un-worn section. Also i added a bit of grease to the inside of mine, figured it can't hurt. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
853 control valve questions
Top