Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
843 drive motor?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="woodhick" data-source="post: 58453" data-attributes="member: 7565"><p>Ordered seals and quad rings for both sides today. Now for a dumb question. I am assuming that the fill level for the lower case is up to the plug that located on the front of the housing? Is that correct? Did pressure wash about 5# of old oil and gunk out of bottom end around the pumps and controls today. Looks like there is a piece of rubber sheet that lays under the hydra-static pumps? Is this original or has someone added this? Also on the bobtatch do they make shims for the pins or do they have to be shop made? Mine has about 3/8" slop and I want to add some shims as it has none in it now. What is the best material for these? Thanks</p></blockquote><p></p>
[QUOTE="woodhick, post: 58453, member: 7565"] Ordered seals and quad rings for both sides today. Now for a dumb question. I am assuming that the fill level for the lower case is up to the plug that located on the front of the housing? Is that correct? Did pressure wash about 5# of old oil and gunk out of bottom end around the pumps and controls today. Looks like there is a piece of rubber sheet that lays under the hydra-static pumps? Is this original or has someone added this? Also on the bobtatch do they make shims for the pins or do they have to be shop made? Mine has about 3/8" slop and I want to add some shims as it has none in it now. What is the best material for these? Thanks [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
843 drive motor?
Top