Reply to thread

Message: <blockquote data-quote="walio123" data-source="post: 105959" data-attributes="member: 9827"><p>There are several models of tensioners. Those who have a point should be tightened while the point goes to 1 hour. If it is without a point a with a spring and a screw -tighten to the end of the thread. If there is nothing, just hang on a bolt with a hanger that sticks upwards, put a pry bar between the belt housing and the hanger, press with one hand and tighten. The belt should be so stretched that at its longest part between the rolls / it is below / when pressed by hand should not move more than 1.5 cm or 1/2 inch. Do not overload it because it will damage the pump bearings and tensioner bearing.</p></blockquote><p></p>