Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
763 F won't go.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="ijoe" data-source="post: 8693" data-attributes="member: 1122"><p>Thanks Ken for the response. As I said in the post above after a few seconds no lights on the bics box. I have read all posts on the box and brakes. Now I need to find where the box gets it power from and if it is getting ~12 volts or maybe reduced voltage. if it is it must be something inside the box. Do you know how to check the 3 wire magnetic proximity switch on the arm. I check the ohm reading on all wires and I get about the same when in both up and down positions. But I don't see how that switch could keep all the lights off on the box. Well tomorrow I will do some more checking. Before reading the posts here I knew nothing about how it works but now I understand enough to start looking. Thanks Joe</p></blockquote><p></p>
[QUOTE="ijoe, post: 8693, member: 1122"] Thanks Ken for the response. As I said in the post above after a few seconds no lights on the bics box. I have read all posts on the box and brakes. Now I need to find where the box gets it power from and if it is getting ~12 volts or maybe reduced voltage. if it is it must be something inside the box. Do you know how to check the 3 wire magnetic proximity switch on the arm. I check the ohm reading on all wires and I get about the same when in both up and down positions. But I don't see how that switch could keep all the lights off on the box. Well tomorrow I will do some more checking. Before reading the posts here I knew nothing about how it works but now I understand enough to start looking. Thanks Joe [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
763 F won't go.
Top