Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
763 drive motor rebuild mishap
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Scaping" data-source="post: 141484" data-attributes="member: 20804"><p>The first motor rebuild went fine. While I was doing the geroler section of the second motor four of the rollers fell out when i turned it over to replace the o ring.I know there is no way I was able to put them back in the same place they fell out of, from what I now understand everything must go back the same way they were. Two of them went in fairly easily but the other two were extremely hard to get in.I have tried to turn the shaft but it feels extremely tight.I"m reluctant to put the motor back in the machine as I don't want to cause any damage to the machine. Is there any way to break it back down and figure out the correct way to get it back together the way it should be? Thank you for any suggestions!</p></blockquote><p></p>
[QUOTE="Scaping, post: 141484, member: 20804"] The first motor rebuild went fine. While I was doing the geroler section of the second motor four of the rollers fell out when i turned it over to replace the o ring.I know there is no way I was able to put them back in the same place they fell out of, from what I now understand everything must go back the same way they were. Two of them went in fairly easily but the other two were extremely hard to get in.I have tried to turn the shaft but it feels extremely tight.I"m reluctant to put the motor back in the machine as I don't want to cause any damage to the machine. Is there any way to break it back down and figure out the correct way to get it back together the way it should be? Thank you for any suggestions! [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
763 drive motor rebuild mishap
Top
