Reply to thread

Message: <blockquote data-quote="daytona701" data-source="post: 121275" data-attributes="member: 18244">Running the machine it would lockup. Turn the key and would start and run then lock up again after a while. The traction lock light would go out when this happened. Then the seat bar light started blinking on/off and the machine would stop but the engine kept running. Figured it was a ground common to both the seat bar sensor and traction lock circuits.Removed the single bolt that secures ground wire and access cover on left side of cab at shoulder height which is a poor design. Also removed bolt on frame just behind cab on left side at shoulder height that secures another ground wire. Cleaned connections and made a new ground wire cable to connect both grounds and reassembled.  Also removed the 30 amp fuse and relay for the traction lock, cleaned the terminals and doused the electrical panel with WD-40. The machine now works without locking up or stopping.</blockquote>