Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
753 locking up and stopping
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Daveb68" data-source="post: 117851" data-attributes="member: 16779"><p>I removed the spring and the magnetic pin and unplugged the solenoid were it goes into the harness and re-installed the cover to keep any debris from getting into that area. </p><p>I'm wondering if I needed to do anything with that end of the plug from the wiring harness we're it is supposed to plug into the solenoid. </p><p>Now that I think of it, I'm pretty sure that I plugged them back together, because the wiring connector plug from the solenoid is still there even after you remove that magnet and spring mechanism on the top piece that you bolt back onto the machine we're that solenoid was to keep any debris out. </p><p>Im not with the machine now but I will look it over when I get back to my shop tomorrow and shoot a few pictures. I will be looking around for any breaks in the wiring harness in that area and check all grounds to be sure they are all good.</p><p></p><p>Thank you for responding, I definitely appreciate the input. </p><p>I will repost when I pin point the problem. </p><p>I did replace the solenoid so it has to be a bad ground or wiring issue, that's the only thing that makes sense. </p><p>Again Thank You,.</p></blockquote><p></p>
[QUOTE="Daveb68, post: 117851, member: 16779"] I removed the spring and the magnetic pin and unplugged the solenoid were it goes into the harness and re-installed the cover to keep any debris from getting into that area. I’m wondering if I needed to do anything with that end of the plug from the wiring harness we’re it is supposed to plug into the solenoid. Now that I think of it, I’m pretty sure that I plugged them back together, because the wiring connector plug from the solenoid is still there even after you remove that magnet and spring mechanism on the top piece that you bolt back onto the machine we’re that solenoid was to keep any debris out. Im not with the machine now but I will look it over when I get back to my shop tomorrow and shoot a few pictures. I will be looking around for any breaks in the wiring harness in that area and check all grounds to be sure they are all good. Thank you for responding, I definitely appreciate the input. I will repost when I pin point the problem. I did replace the solenoid so it has to be a bad ground or wiring issue, that’s the only thing that makes sense. Again Thank You,. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
753 locking up and stopping
Top