Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
751C Pug won’t start
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="751C PugBobcat" data-source="post: 110357" data-attributes="member: 18500"><p>Hi, I picked up a 2000 751C with the Peugeot engine not running. Turns over fine. Did the timing belt, new glow plugs and had the injection pump and injectors serviced. No problem priming it and bleeding out the air from the filter and pump. Timing is spot on. Tried a shot of ether and a bit of white smoke comes out but won't start. Compression is 300 in all 4 cylinders so I think it should still at least start. Fuel is good, filter is good, motor doesn't bind at all. Machine has 2100 hours on it and seems legit. Guy I bought it from said it likely needs rings. I've tried almost everything and it just won't fire up. Am I wrong about the compression and it needs a rebuild? Thanks in advance. If it needs the motor pulled I'll have some more questions since I read it's better to leave the drive pump installed. 751C Pugbobcat</p></blockquote><p></p>
[QUOTE="751C PugBobcat, post: 110357, member: 18500"] Hi, I picked up a 2000 751C with the Peugeot engine not running. Turns over fine. Did the timing belt, new glow plugs and had the injection pump and injectors serviced. No problem priming it and bleeding out the air from the filter and pump. Timing is spot on. Tried a shot of ether and a bit of white smoke comes out but won’t start. Compression is 300 in all 4 cylinders so I think it should still at least start. Fuel is good, filter is good, motor doesn’t bind at all. Machine has 2100 hours on it and seems legit. Guy I bought it from said it likely needs rings. I’ve tried almost everything and it just won’t fire up. Am I wrong about the compression and it needs a rebuild? Thanks in advance. If it needs the motor pulled I’ll have some more questions since I read it’s better to leave the drive pump installed. 751C Pugbobcat [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
751C Pug won’t start
Top