Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
743 head
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 8470" data-attributes="member: 82"><p>Glad its alive again!</p><p>To replace the seal you need to pull the engine out. This will be good to allow cleaning.</p><p>Just remove the attached hoses and throttle linkage, remove the 4 bolts holding the engine to the chassis and pull it out and up over the lip on the back.. I used a small air hoist with a chain joining to the 2 lifting points on the head.</p><p>To put it back in is a little more tricky, you need to lift the engine back in, slide it back but not all the way, you need someone laying on the hydro pump to hold the drive to the pump and get it to line up then slowly sneak it forward with pry bars.</p><p>After you have done it a few times its pretty simple.</p><p>If you pull the engine, ensure you grease the universal joints! its a pain to grease when its back in the machine.</p></blockquote><p></p>
[QUOTE="Tazza, post: 8470, member: 82"] Glad its alive again! To replace the seal you need to pull the engine out. This will be good to allow cleaning. Just remove the attached hoses and throttle linkage, remove the 4 bolts holding the engine to the chassis and pull it out and up over the lip on the back.. I used a small air hoist with a chain joining to the 2 lifting points on the head. To put it back in is a little more tricky, you need to lift the engine back in, slide it back but not all the way, you need someone laying on the hydro pump to hold the drive to the pump and get it to line up then slowly sneak it forward with pry bars. After you have done it a few times its pretty simple. If you pull the engine, ensure you grease the universal joints! its a pain to grease when its back in the machine. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
743 head
Top