Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
743 head
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 8451" data-attributes="member: 82"><p>Clearance at TDC is .007 - .009 i work on .008 as its a mid-point.</p><p>I will need to look up head bolt tension if you need them.</p><p>That gasket sounds a bit pricy, i can get an aftermarket FULL gasket set for around $170 AUD.</p><p>Have a look at <a href="http://www.tractorimports.com.au/shop/categories.asp?cID=41" target="_blank">http://www.tractorimports.com.au/shop/categories.asp?cID=41</a></p><p>OR <a href="http://www.tractorimports.com.au" target="_blank">www.tractorimports.com.au</a> then follow the links.</p><p>With the bare head, do remember you will need to get the valves ground and the stems may be worn. Just keep this all in mind, there is no point in half doing the job. You will also need valve stem seals.</p><p>Good lock with it. If you have any questions just let me know, i have done a few of these before and i have the manual for it too.</p></blockquote><p></p>
[QUOTE="Tazza, post: 8451, member: 82"] Clearance at TDC is .007 - .009 i work on .008 as its a mid-point. I will need to look up head bolt tension if you need them. That gasket sounds a bit pricy, i can get an aftermarket FULL gasket set for around $170 AUD. Have a look at [URL]http://www.tractorimports.com.au/shop/categories.asp?cID=41[/URL] OR [URL='http://www.tractorimports.com.au']www.tractorimports.com.au[/URL] then follow the links. With the bare head, do remember you will need to get the valves ground and the stems may be worn. Just keep this all in mind, there is no point in half doing the job. You will also need valve stem seals. Good lock with it. If you have any questions just let me know, i have done a few of these before and i have the manual for it too. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
743 head
Top