Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
743 glow plugs?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 3616" data-attributes="member: 82"><p>Yo don't need to pull the engine apart as such, you just need to loosen the inlet manifold and remove 1 or 2 injector lines. Seriously, its not difficult, it just takes a bit of time. Give the inlet side of the engine a good clean before you start so you don't get any dust in the engine.</p><p>Remove the air intake hose, and un-do the bolts holding the manifold in place. You will need to remove i think number 2 and 3 injector lines at the pump, you will need to remove the 2 clamps holding the injector lines together. Remove the lines at the pump, and loosen them at the injectors and you should be able to swing them out of the way.</p><p>Remove and replace the glow plugs then re-assemble.</p><p>It does take time, but its not that difficult.</p></blockquote><p></p>
[QUOTE="Tazza, post: 3616, member: 82"] Yo don't need to pull the engine apart as such, you just need to loosen the inlet manifold and remove 1 or 2 injector lines. Seriously, its not difficult, it just takes a bit of time. Give the inlet side of the engine a good clean before you start so you don't get any dust in the engine. Remove the air intake hose, and un-do the bolts holding the manifold in place. You will need to remove i think number 2 and 3 injector lines at the pump, you will need to remove the 2 clamps holding the injector lines together. Remove the lines at the pump, and loosen them at the injectors and you should be able to swing them out of the way. Remove and replace the glow plugs then re-assemble. It does take time, but its not that difficult. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
743 glow plugs?
Top