Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 Tilt cylinder
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="rjitreeman0909" data-source="post: 103269" data-attributes="member: 15919"><p>Remount the rod end to the bobcat. That will keep the shaft from rotating when you apply torque to nut. Check to make sure there isn't a roll pin thru the nut rather than loctite. If there is, you may need to rotate nut slightly in the tighten direction to relieve the bind created by prior attempt to remove.</p></blockquote><p></p>
[QUOTE="rjitreeman0909, post: 103269, member: 15919"] Remount the rod end to the bobcat. That will keep the shaft from rotating when you apply torque to nut. Check to make sure there isn't a roll pin thru the nut rather than loctite. If there is, you may need to rotate nut slightly in the tighten direction to relieve the bind created by prior attempt to remove. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 Tilt cylinder
Top