Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 Tilt cylinder
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="GILL" data-source="post: 103192" data-attributes="member: 265"><p>I've got this 732 with a leaky tilt cylinder. Oil coming from around the rod seal. I've purchased a rebuild kit and made a spanner wrench to get the cap off. The problem I'm having is getting the nut off the piston so I can remove it and the slid the cap off to replace the seals and O-rings. Has anyone had any experience getting this nut (which is beveled) off? It measures at 1.642" across the flats. Not a 1-5/8 really and a sloppy fit for a 1-11/16 socket. My Bobcat book tells a lot about it but not nearly enough to suit me especially about putting the seals in the cap. They call out a special tool for this. Is something like this really needed? Thanks in advance, Greg</p></blockquote><p></p>
[QUOTE="GILL, post: 103192, member: 265"] I've got this 732 with a leaky tilt cylinder. Oil coming from around the rod seal. I've purchased a rebuild kit and made a spanner wrench to get the cap off. The problem I'm having is getting the nut off the piston so I can remove it and the slid the cap off to replace the seals and O-rings. Has anyone had any experience getting this nut (which is beveled) off? It measures at 1.642" across the flats. Not a 1-5/8 really and a sloppy fit for a 1-11/16 socket. My Bobcat book tells a lot about it but not nearly enough to suit me especially about putting the seals in the cap. They call out a special tool for this. Is something like this really needed? Thanks in advance, Greg [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 Tilt cylinder
Top