Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 No Lift - Tilt and motion fine
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 101277" data-attributes="member: 82"><p>As flyerdan said, if you need to pull the pump and hoses, rubber bands and plastic bags and rags will help keep the mess down somewhat.</p><p>Remove the main drive motor hoses at the motors, leave the pump end on, they are hard to access.</p><p>When i have done this sort of work, i did find i didn't need to lift the arms, not sure if it would be easier with the up in the air or not. If you do, make sure it is vell supported and that you install a jack under the rear of the machine to stop it tipping backwards.</p><p>I'm wondering, if you remove the engine, and the front pump mounts, if you can tilt the pump up enough to access the plate to get access to the broken off bolt. With the engine in place, i don't think you will get the required angle.</p></blockquote><p></p>
[QUOTE="Tazza, post: 101277, member: 82"] As flyerdan said, if you need to pull the pump and hoses, rubber bands and plastic bags and rags will help keep the mess down somewhat. Remove the main drive motor hoses at the motors, leave the pump end on, they are hard to access. When i have done this sort of work, i did find i didn't need to lift the arms, not sure if it would be easier with the up in the air or not. If you do, make sure it is vell supported and that you install a jack under the rear of the machine to stop it tipping backwards. I'm wondering, if you remove the engine, and the front pump mounts, if you can tilt the pump up enough to access the plate to get access to the broken off bolt. With the engine in place, i don't think you will get the required angle. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
732 No Lift - Tilt and motion fine
Top